Installation manual

90-898305
1-44
PRIMING THE OIL INJECTION PUMP
a. Connect the fuel hose. Fill the fuel system by squeezing the primer bulb.
Squeeze the fuel line primer bulb until it feels firm.
b. Turn the ignition key switch to the “ON” position for three seconds. This
operates the electric fuel pump.
c. Turn the ignition key switch back to the “OFF” position, and squeeze the
primer bulb again until it feels firm. Turn the ignition key switch to the “ON”
position again for three seconds. Continue this procedure until the fuel line
primer bulb stays firm.
2. Turn the ignition key switch to the “ON” position.
3. Within the first 10 seconds after the key switch has been turned on, move
the remote control handle from neutral into forward gear 3 to 5 times. This will
automatically start the priming process.
NOTE: It may take a few minutes for the pump to complete the priming
process.
Purging Air From the Engine Oil Tank
1. Loosen the fill cap on the engine oil tank.
2. Start the engine. Run the engine until the all the air has been vented out of
the tank and oil starts to flow out of the tank. Re-tighten fill cap.
Notes
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________