Installation manual

90-898305
1-42
4. There are three methods for activating the priming process.
• CDS-Oil Pump Prime in ACTIVE TEST will activate the priming
process.
•
DDT-Oil Pump Prime in SPECIAL FUNCTIONS will activate the
priming process.
•
Within the first 10 seconds after the key switch has been turned on,
move the remote control handle from neutral into forward gear 3 to 5
times. This will automatically start the priming process.
NOTE: It may take a few minutes for the pump to complete the priming
process.
Oil Injection Set-Up
1. Fill remote oil tank with the recommended oil listed in the Operation and
Maintenance Manual. Tighten fill cap.
2. Remove cap and fill engine oil tank with oil. Reinstall the fill cap.
Notes
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________