Installation manual

1-41

90-898305

Torque Specifications

Engine Not Running

CABLES NOT CONNECTED (OUTBOARD MODELS)

NOTE: The torque specifications do not reflect the force required to move the

handle through the detent.

1. Measure the torque by moving the remote control handle to the detent. If

the torque is not within specifications, inspect the cable routing and ensure

that it is not binding.

Priming the Fuel and Oil System

NOTE: For initial start of a new engine or for an engine that ran out of fuel, or

was drained of fuel, essentially any time maintenance to the system is

required:

1. Squeeze the fuel line primer bulb until it feels firm.

2. Turn the ignition key switch to the “ON” position for three seconds. This

operates the electric fuel pump.

3. Turn the ignition key switch back to the OFF position, and squeeze the

primer bulb again until it feels firm. Turn the ignition key switch to the “ON”

position again for three seconds. Continue this procedure until the fuel line

primer bulb stays firm.

Notes

_______________________