Installation manual

1-27

90-898305

Dual Engine

IMPORTANT: The location of the junction box termination resistors are critical

forproper system function. All unused junction box ports must be sealed with a

weathercap. Disconnect the power harness on the port engine.

If running a single CAN bus (blue data cable) on dual or more engine

installations, only one engine is used to supply 12 volt power. On the

remaining engines, disconnect the 3 wire CAN power harness under the cowl

as shown below. This connector is about 3 inches from the under cowl

SmartCraft data cable (blue boat cable) connection. Plug the connectors with

caps as shown.

NOTE: Engine electrical damage may result if more than one engine powers

this system. A failure of this nature is not covered under normal engine

warranty.

Notes

_______________________