Installation manual

1-19

90-898305

Panel Mount Control Wiring Connections

1. Connect the trim harness and lever harness.

2. Insert the bayonet end of the lever harness into the bracket hole. This will

prevent the connector from pulling out. See illistration below

3. Connect the lanyard stop switch bullet connectors.

IMPORTANT: Allow slack in the trim harness. Harness will flex and move

during control handle movement.

DTS Wiring Guidelines

• Never attempt to connect, network, tie into, switch, and/or sink source

voltage or current from the DTS wiring harnesses.

• Never attempt to connect any type of communication or navigation

equipment into the DTS wiring harnessing other than at the designated

connection point.

• Boat accessory equipment being installed must be connected to an

appropriate power source such as a fuse panel or junction block.

• Never attempt to tap directly into any of the DTS electrical wiring harnesses

for a source of power.

Notes

_______________________