Installation manual

90-898305

1-18

Single Helm Command Module Harness Installation

1. Connect the 14 pin Deutch connector on the command module harness to

the 14 pin data harness.

2. Ensure the CAN 1 and CAN 2 connectors have terminator resistors

installed, and the CAN 3 connector is sealed with a weather cap.

CAN 1

Gauges and back up for DTS

CAN 2

DTS data communication

CAN 3

Vessel Systems (Racing trim tabs)

inputs

DTS Command Module History

IMPORTANT: DTS Command Modules must not be intermixed with different

model year DTS Command Modues. The model year of the command module

must match the model year of the PCM calibration.

Notes

_______________________