Installation manual

1-17

90-898305

Command Module Installation

1. Plug the command module connector into the command module.

2. To minimize vibration, mount the command module with the supplied rubber

grommets/bushings according to the following guidelines:

• Mount in an area that is accessible

• Mount in an area where the wiring connections will not be stepped on or

disturbed

• Mount with the Command Module connector facing down to prevent water

intrusion.

• Fasten the command module harness to prevent flexing at the command

module connection.

IMPORTANT: Avoid sharp bends in the cable. The minimum bend radius

should be7.6 cm (3 in.).

Notes

_______________________