Owner's Manual

2. Press and hold the MODE
control until VAR appears in the
display, then release. The display
should show the current zone
number.
3. Press the MODE control until
the desired zone number appears.
The display will flash and then
return to normal operation. The
zone is now updated.
Compass calibration adjustment
Perform this adjustment in an
open area free from steel
structures and high voltage lines:
• Press and hold the MODE
control until CAL appears in the
display (approximately eight
seconds) and release.
• Drive the vehicle slowly (less
than 5 km/h [3 mph]) in circles
until CAL indicator turns off in
about 2–3 complete circles.
AUTOLAMP DELAY SYSTEM
(IF EQUIPPED)
The autolamp sets the headlamps
to turn on and off automatically.
The autolamp may be set to:
• turn on the lamps automatically
at night
• turn off the lamps automatically
during daylight
• keep the lamps on for up to
three minutes after the key is
turned to OFF
LAMP
MODE
LAMP
9 VAR
LAMP
MODE
LAMP
CAL
Controls and features
37