Owner's Manual

Controls and Features
117
*
[CF75100(ALL)01/96]
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC
RULES. OPERATION IS SUBJECT TO THE FOLLOWING
TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE
HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST
ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING
INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION.
[CF75200(ALL)01/96]
Replacement/Additional Transmitters
[CF75300(ALL)01/96]
In the event a transmitter is lost or an additional remote
transmitter needs to be set, you must change the ID code.
Follow the steps below to change the ID code of your system,
or return the remaining transmitter(s) to your dealer for
reprogramming of your remote entry system. This is necessary
to prevent unauthorized use of the lost transmitter.
[CF75400(ALL)01/96]
ID Code Programming Procedure
[CF75500(ALL)01/96]
NOTE: All transmitters must be programmed (or
reprogrammed) at the same time. If the programming
mode is entered and the transmitters are not
programmed (or reprogrammed) at the same time, they
will not operate with the system.
[CF75600(ALL)01/96] 1. Enter vehicle and close and lock all doors.
[CF75700(ALL)01/96] 2. Insert and remove key from ignition six times within ten (10)
seconds. The instrument panel lights will flash twice.
[CF75800(ALL)01/96] 3. Turn ignition key to the ACC position.
[CF75900(ALL)01/96] 4. Press the LOCK button on the remote transmitter once.
[CF76000(ALL)01/96] 5. To enter additional remote controllers (including the
original), unlock, then lock the driver’s door using the power
door lock switch.
File:05vxcfn.ex
Update:Thu May 30 09:49:09 1996