Owner's Manual

249
[SV20500(MBC )03/95]
3.8L engine only
[SV20601(MBC )03/94]
❑
Open the vent plug.
[SV20700(MBC )03/93]
❑
Remove coolant recovery reservoir cap.
[SV20801(MBC )03/93]
❑
Remove radiator pressure cap.
[SV20900(MBC )05/94]
❑
With the engine off and cool, add a 50/50
mixture of recommended cooling system fluid
and water to the radiator until full, then add
to the reservoir until the reservoir is at the
FULL-HOT level.
[SV21000(MBC )12/91]
❑
Close the vent plug.
[SV21100(MBC )03/93]
❑
Reinstall the coolant recovery reservoir cap
by installing the cap to the fully installed
position.
[SV21110(MBC )03/93]
❑
Reinstall the pressure cap to the pressure
relief position by installing the cap to the
fully installed position, and then backing off
to the first stop.
[SV21200(MBC )03/93]
❑
Start and idle engine until the radiator upper
hose is warm (this indicates the thermostat is
open and coolant is flowing through the
entire system).
[SV21300(MBC )03/93]
❑
Immediately shut off engine. Cover cap
completely with a thick cloth and cautiously
remove radiator pressure cap and add a
50/50 mixture of recommended coolant and
water until system is full.
[SV21400(MBC )03/91]
❑
Reinstall the radiator cap securely.
[SV21500(MBC )05/94]
❑
Remove the cap from the engine coolant
recovery reservoir and add a 50/50 mixture
of recommended cooling system fluid and
water to the FULL-HOT mark on the engine
coolant recovery reservoir. Check that
reservoir hose is not kinked.
[SV21800(MBC )03/93]
❑
Reinstall the reservoir cap.
File:rcsvc.ex
Update:Mon Jun 12 16:45:15 1995