Assembly Instruction

STEP 6 - Install the Bulb
A. Insert the bulb onto the socket and screw snugly into place.
Your fixture is now assembled and ready to use. Enjoy!
Figure 6
(Step 3 Continued)
rest against the ceiling
when held in place by the
Canopy Lock Ring (FF).
D. Remove the Canopy Lock
Ring (FF) and the Ceiling
Canopy (II). Tighten the
Hex Nut (CC) against the
Crossbar (AA) to secure in
place.
AA
BB
CC
Step B
Step A
DD
CC
BB
EE
II
FF
Figure 3
DD
GG
II
EE
FF
HH
HH
Fixture
Loop
Supply
Wires and
Ground Wire
STEP 4 - Install the Fixture Chain and Ceiling Canopy
A. Adjust the Fixture Chain (GG) to your desired length by removing
links if needed.
B. Pull the supply wires through the Fixture Chain (GG) alternating
links. After the wires are through the Fixture Chain (GG), pull the
Supply Wires and the Ground Wire through the Canopy Lock Ring
(FF) and the Ceiling Canopy (II) in order.
C. Attach one end of the Fixture Chain (GG) to the Fixture Loop with
one Quick Link (HH). Lift the fixture and Fixture Chain (GG) up and
attach the other end of the Fixture Chain (GG) onto the Canopy
Chain Loop (EE) with another Quick Link (HH). The fixture will now
hang safely.
D. Feed the Supply Wires and Ground Wire through the Canopy Chain
Loop (EE) and Nipple (DD) into the Outlet Box. Cut the wires leaving
approximately 8” of wire extending from the Outlet Box.
E. Go to Step 5 for wire connections and follow the directions. Return
to Step F in this step when complete with Step 5.
F. Raise the Ceiling Canopy (II) and Canopy Lock Ring (FF) up the
Figure 4
Fixture Chain (GG) and over
the Canopy Chain Loop (EE).
Tighten the Canopy Lock Ring
(FF) onto the Canopy Chain
Loop (EE) until tight.
Suggested chain length for
Ceiling height :
8’ ceiling : use 10 links of chain
and 2 quick links
9’ ceiling : use 20 links of chain
and 2 quick links
10’ ceiling : use 30 links of
chain and 2 quick links
Figure 5
STEP 5 - Making the Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into outlet box.
Note: If the electrical wire is going to be cut shorter than provided
you will need to identify the "L" line wire and the "N" neutral wire
before you cut the excess wire off. One is labeled N and the other
labeled L. To do this separate the "L" line wire and the "N" neutral
wire as far as you need to. Re-label the wire near where you want to
make the cut. Be sure to mark the wire on the side of the fixture and
not on the excess wire being cut and removed.
B.
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire from fixture
identified with the Label “N”
Black wire from
outlet box (or Red)
Black wire from fixture
identified with the label “L”
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture
Socket
Vintage Bulb
(recommended
but not Supplied)
Thank you for purchasing this product.
2of3