Assembly Instruction

ManualsBrandsMercury Row ManualsBlack Outdoor Hanging LightsAinsworth Earth Black 1 -Bulb 20.75'' H Outdoor Hanging Lantern

1of3

Package Contents

Hardware Contents

Crossbar

Lock Washer

Hex Nut

Nipple

Canopy

Chain Loop

Canopy Lock

Ring

Ceiling Canopy

Fixture Chain

Quick Link

Fixture Loop

Warnings and Cautions

Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.

These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly

recommend that a licensed, professional electrician perform the installation.

Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.

(1)A21MediumBasebulb150WMaximumor

(1)MediumBaseVintageBulbisrecommendedbutnotsupplied.

20-30minutes

Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtoensureallpartsare

present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactcustomerserviceforreplacement

parts.

LightSource:

EstimatedAssembly Time:

Preparation:

ToolsRequired:Flatheadscrewdriver, Phillips screwdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.

Waterproof

Washer

Glass Panel

Fixture Body

STEP 1 Install Glass Panels-

A. Insert the Glass Panel (C) into the

cage with beveled edge is

outside. Attach the top edge of the

Glass Panel (C) to the slot in the

top of the cage. Fold tabs in the

bottom edge of the cage to secure

Glass Panels (C).

B. Place the Waterproof Washer (B)

over the nipple on the top center

of the Fixture Body (D) and thread

the Fixture Loop (A) onto the

nipple. Hand tighten until snug.

Figure 1

Slot

Cage

Tab

STEP 2 Install the Crossbar to the junction box-

A. Attach the Crossbar (AA) to the Outlet Box with the head of the

Green Ground Screw facing you. Secure it with Outlet Box Screws

(not included), tighten until snug

Figure 2

Outlet Box

Outlet Box Screw

(not included)

Green Ground

Screw

STEP 3 Install the Canopy Chain Loop and Nipple-

A. Thread one Hex Nut (CC) to one end of the Nipple (DD) until it is at

least 0.25” from the end. Pass one Lock Washer (BB) over the end

of the Nipple (DD) and thread the Canopy Chain Loop (EE) onto the

Nipple (DD). By using pliers, thread the Hex Nut (CC) against the

Canopy Chain Loop (EE) and hand tighten until snug.

B. Thread another Hex Nut (CC) to the middle of the Nipple (DD).

Place another Lock Washer (BB) over the Nipple (DD) and then

thread the Nipple (DD) into the Crossbar (AA) until the Nipple (DD)

is about 0.375” above the Crossbar (AA).

C. Remove the Canopy Lock Ring (FF) from the Canopy Chain Loop

(EE). Place the Ceiling Canopy (II) over the Canopy Chain Loop

(EE) against the ceiling to determine the correct position of the

Nipple (DD). Thread the Canopy Lock Ring onto the Canopy Chain

Loop (EE). Adjust the Nipple (DD) to allow the Ceiling Canopy (II) to

Assembly Instruction Sheet

Thank you for purchasing this product.

Summary of content (3 pages)

PAGE 1
Assembly Instruction Sheet Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses. Light Source: (1) A21 Medium Base bulb 150W Maximum or (1) Medium Base Vintage Bulb is recommended but not supplied. Estimated Assembly Time: 20-30 minutes Preparation: Identify and inspect all parts before beginning installation. Check package content list and diagrams below to ensure all parts are present.
PAGE 2
(Step 3 Continued) rest against the ceiling when held in place by the Canopy Lock Ring (FF). D. Remove the Canopy Lock Ring (FF) and the Ceiling Canopy (II). Tighten the Hex Nut (CC) against the Crossbar (AA) to secure in place. STEP 5 - Making the Wire Connections BB AA CC Step B DD A. Wrap bare or green ground wire around green ground screw on the crossbar, no less than 2 inches from the end of the wire. Tighten the green ground screw. B.
PAGE 3
FINISH: EARTH BLACK NOTE: ALL DIMENSIONS ARE ROUNDED UP TO THE NEAREST 1/4" 5" Dia. 122.5” OVERALL HEIGHT ( INCLUDES 96” CHAIN AND 2 QUICK LINKS ) 20.75" 7" 7" Thank you for purchasing this product.