Installation & Assembly (Table)

ManualsBrandsMercury Row ManualsOutdoor & Patio FurnitureRound 2 - Person 27.5'' Long Bistro Set with Cushions

Table Of Contents

Assembly Instructions

Caution: You must read this before you proceed

Table

Caution: This Table is NOT a TOY

Keep your child/ children at bay during the assembly process.

For moving the Table and to prevent damage to the Table, two adults may be

needed to execute these actions.

Please look in the First Leg Panel for hardware packs.

Page 1 of 6

Summary of content (6 pages)

PAGE 1
Assembly Instructions Caution: You must read this before you proceed Please look in the First Leg Panel for hardware packs. Table Caution: This Table is NOT a TOY Keep your child/ children at bay during the assembly process. For moving the Table and to prevent damage to the Table, two adults may be needed to execute these actions.
PAGE 2
Parts List Label Picture Description QTY A Table Top 1 B First Leg Panel (Labelled B) 1 C Second Leg Panel (Labelled C) 1 Description QTY ① Screws (M6x45mm) 9 ② Allen Key 1 Hardware Label Picture Assembly Preparation Before Beginning Assembly: Page 2 of 6
PAGE 3
Assembly Steps Overview Table Top (A) Second Leg Panel (C) First Leg Panel (B) FRONT FACING This Table has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Table parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 Unpack and place all parts on a clean non -marring surface.
PAGE 4
Step 2 2 B 1 A Place the Table Top ( A) facedown on a clean, non-maring suface. Position the First Leg Panel (B) on to the Table Top(A). Insert three Screw (①),through the mounting positions of the First Leg Panel ( B) and affix using the Allen Key(②) Only loosely tighten the Screws. Step 3 Step 3.3 2 1 C 2 B 1 Step 3.1 A Step 3.2 3.1)Position seperated point of the Second Leg Panel (C) over the First Leg Panel (B) on to the Table Top(A). 3.
PAGE 5
Step 4 If wobble Test again 30cm-50cm Place the Table right side up on a LEVEL SURFACE to see if it wobbles. If it wobbles,lift the Table to some 30cm to 50cm height from the ground. Keep your feet and tose weell away from the drop zone. Drop the Table freely and vertically with the four legs,hitting the ground,at the same time.This Drop Test will help to ensure that all the Screws and gaps all reach full alignment status. Test again for evenness on a LEVEL SURFACE .
PAGE 6
Page 6 of 6