4 Piece Multiple Chairs Seating Group with Cushions
PART LIST C B A D E (arm chair) (loveseat) Back Panel 2 PCS Back Panel 1 PC (arm chair) Left Arm Panel 3 PCS Right Arm Panel 3 PCS H G F Seat Panel 2 PCS I J (loveseat) (arm chair) Top Panel 1 PC Seat Panel 1 PC K Side Panel 2 PCS Seat Cushion 2 PCS L (loveseat) (loveseat) Seat Cushion 1 PC Back Cushion 2 PCS HARDWARE LIST #2 #1 M6*15mm Short Bolt 39 PCS (Extra 2) #3 M6*30mm #4 M6mm Long Bolt Flat Washer 4 PCS (Extra 2) 43 PCS (Extra 2) 2 M6mm Allen Wrench 1 PC (arm c
Step 1. Lay left arm panel (part A) upside down on a soft flat surface, such as carpet, as shown below. Attach seat panel (part C) to left arm panel (part A) using short bolts (part #1), flat washers (part #3) and allen wrench (part #4). NOTE: Please do not fully tighten bolts until unit is fully assembled. #4 #1 #3 C #1 x4 #3 x4 #4 x1 Step 2. Attach back panel (part D) to assembled unit (parts A & C) using short bolts (part #1), flat washers (part #3) and allen wrench (part #4).
Step 3. Attach right arm panel (part B) to back panel (part D) and seat panel (part C) using short bolts (part #1), flat washers (part #3) and allen wrench (part #4). NOTE: Please fully tighten all bolts at this time. B C #3 #1 #4 #3 D #1 #4 #1 x5 #3 x5 #4 x1 Step 4. Carefully turn unit upright. Place seat cushion (part I) and back cushion (part J) as shown below. Repeat steps 1-4 to assemble remaining chair.
Step 5. Lay left arm panel (part A) upside down on a soft flat surface, such as carpet, as shown below. Attach seat panel (part F) to left arm panel (part A) using short bolts (part #1), flat washers (part #3) and allen wrench (part #4). NOTE: Please do not fully tighten bolts until unit is fully assembled. #4 #1 #3 F A #1 x4 #3 x4 #4 x1 Step 6. Attach back panel (part E) to assembled unit (parts A & F) using short bolts (part #1), flat washers (part #3) and allen wrench (part #4).
Step 7. Attach right arm panel (part B) to back panel (part E) and seat panel (part F) using short bolts (part #1), flat washers (part #3) and allen wrench (part #4). NOTE: Please fully tighten all bolts at this time. B #3 #1 #4 F E #3 #1 #4 #1 x5 #3 x5 #4 x1 Step 8. Carefully turn unit upright. Place seat cushion (part K) and back cushions (part L) as shown below.
Step 9. Lay top panel (part G) upside down on a soft flat surface, such as carpet, as shown below. Attach side panels (part H) to top panel (part G) using short bolts (part #1), long bolts (part #2), flat washers (part #3) and allen wrench (part #4). NOTE: Please fully tighten all bolts at this time. #4 #2 #3 H H G #4 #1 #3 Step 10. Carefully turn unit upright.