Installation & Assembly

Adjust Pre-installed Levelers
height to achieve balance.
E
F
G
H
A
B
C
D
Attach table base frame to bottom of Top Panel (A) using Bolt (E), Spring Washer (F), Flat
Washer (G) with Allen Key (H).
Note: At this stage, tighten all Bolts at all joints fully in a sequential manner.
Adjust the pre-installed levelers at the bottom of Support Frame (B) and Side Frame (C)
until the Dining Table is level with the ground.
Treat surface with care. Surface is resistant to scratches but is not scratch resistant. Clean
surfaces with a dry or damp soft cloth. Do not use abrasive cleaners. Hardware may loosen over
time. Periodically check that all connections are tight.
Cleaning & Care
3
B
C