Caution : You must read this before you proceed Chair Label Picture Description QTY A Seat 1 B Right Armrest (with Pre-Installed Levellers) 1 C Left Armrest (with Pre-Installed Levellers) 1 D Seat Cushion 1 E Back Cushion 1 Page 1 OF 5
Label Picture Description QTY ① Bolt (M6*40MM) 5 ② Bolt (M6*32MM) 3 ③ Washer 7 ④ Allen Key 1 Before Beginnin g Assembly : X5 Overview Back Cushion(E) X3 X7 Right Armrest(B) Seat Cushion(D) Left Armrest(C) Seat(A) FRONT FACING This Chair has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Chair parts, the above picture is to help you put the various parts into perspective.
Step 1 1.2 1.1 Open the carton and place all the parts onto a clean, non-marring surface. Place the Right Armrest(B) facedown. 1.1) With the assistance of your adult partner, turn the Seat(A) over and align it to the Right Armrest(B). 1.2) Attach Seat(A) to Right Armrest(B) using Bolts(①) and Washers(③) with Allen Key(④) as shown above. Attach Seat(A) to Right Armrest(B) using Bolt(②) and Washer(③)with Allen Key(④) as shown above. Do not fully tighten the Bolts. Step 2 2.1 2.
Step 3 In a sequential manner, proceed to tighten all Bolts. DO NOT tighten any Bolt fully and then move on to the next one, this may cause the frame to warp. Then, with the assistance from an adult partner, stand the Chair upright. Adjust the Pre-installed Levellers until the Chair is level with the ground. To adjust the Levellers: with the assistance from an adult partner, tilt the Chair to rest on two feet. Adjust the levellers to the desired height to avoid wobbles.
Page 5 OF 5
