ASSEMBLY INSTRUCTION END TABLE Top Panel H Leg Lower Cross Bar EJ Upper Cross bar 1PC PCS 1PC 1PC El Metal Bracket ll Cam Lott El Cam Screw BI Cam Nut 1/4"X 2" 3/8"x 1/4" 19/32"X 9/16" PCS PCS PCS PCS Il Wooden Dowel Bolt Allen Key 4mm Sup Drum Tc PCS PCS 1PC This page lists all the contents included in the box. Please take the time to identify the hardware as well as the individual components to this product. As you unpack and prepare for assembly.
Attach the Metal Bracket (E) to the Leg (B) by using Bolt (J) with Allen Key (K). Screw Cam Bolt (F) to the per-drilled hole of the Leg (B) as below shown, and then insert Wood Dowel (I) into Long Connecting Rod (C) and Short Connecting Rod (D) as below shown. Insert Wood Dowel (1) into the per-drilled holes of the cross bar of Top Panel (A} as below shown, then attach one Leg (B) to Top Panel (A) by using Bolt (J) with Allen Key (K).
Attached the Lower Cross Bar (C) to the assembled Leg (B) by using Cam Nut (H} and Cam Screw (G) with Allen Key (K) as below shown, then attached another Leg (B}) to the Lower Cross Bar (C) by using Cam Nut (H) and Cam Screw (G) with Allen Key (K), then Lock the Leg (B} into the Table Top (A) by using Bolt (J) with Allen Key (K) as below drawing.
Adjust the per-installed levelers at the bottom of the Leg (B) until the chair is level with the ground. Adjust Pr-installed levelers height to achieve balance. Cleaning & Care Treat surface with care. Surface is resistant to scratches but is not scratch resistant. Clean surfaces with a dry or damp soft cloth. Do not use abrasive cleaners. Hardware may loosen over time. Periodically check that all connections are tight.
