Assembly Instruction

* - The two plastic washers are for the purpose of protecting mirror surface. Please place one of the

washers inside of the drawer and place the other one between front of the drawer and drawer knob.

Cleaning & Care

Treat surface with care. Surface is resistant to scratches but is not scratch resistant. Clean surfaces with a dry

or damp soft cloth. Do not use abrasive cleaners. Hardware may loosen over time. Periodically check that all

connections are tight.

Using bolt (I) and allen wrench (K) again, attach short stretcher (F) between front right leg (C)/back

leg (E), and front left leg (D)/back leg (E) Then, attach long stretcher (G) to back leg (E) as shown.

Attach end cap (J) to leg (C) (D) (E). Please

tighten all bolts at this step.

Carefully turn the assembled unit upright

Remove drawer knob w/ plastic washers (H) from inside of the drawer and reattach on drawer front

as shown. The mirrored desk assembly is now complete.