General Assembly Guidelines I. Ensure that all parts and hardware are available before beginning assembly. II. Follow each step carefully to ensure the proper assembly of this product. III. Two people are recommended for ease in the assembly of this product. IV. The three main types of hardware used to assemble this product are: wood dowels, screws and bolts. V. The provided glue is to secure wood dowels in place.
Parts List 1 4 3 2 2 3 4 5 5 6 8 7 8 7 P.
Hardware List A Ø8x30mm Wooden dowel 24 pcs B Ø6x35mm Cam bolt 18 pcs C Ø15x11mm Cam lock 18 pcs D Ø30mm Sticker 18 pcs E Ø6x50mm Screw 10 pcs F Ø6x13mm Bolt 24 pcs G M4 Hex key 1 pc H Plastic wedge 8 pcs J Connecting iron sheet 4 pcs K Shelf support pin 8 pcs L Glue tube 1 pc Philips head screwdriver required for assembly (not included) The hardware quantities listed above are required for proper assembly. Some extra hardware may also have been included.
Step 1 A A A A A B B A A 2 3 4 B A A A A B A x2 Insert wooden dowel (A) into parts (2,3,4),then secure cam bolts (B) into parts (3,4)with Philips head screwdriver as per diagram. P.
Step 2 B B B B B 1 B B B B B Secure cam bolt (B) into part (1) with Philips head screwdriver as per diagram. P.
1 Step 3 2 C 3 4 C 2 x2 Using cam lock (C) secure part (4) into part (2) with Philips head screwdriver as per diagram. P.
1 Step 4 3 2 3 C C 2 x2 Repeat the last step as per diagram. P.
Using screw (E) attach part (6) to parts (2,3,4) with hex key (G) as per diagram.
Using Bolt (F) attach plastic wedge (H) to parts (7,8), connecting iron sheet (J) to part (8) with Hex key (G) as per diagram.
Using bolt (F) attach connecting iron sheet (J) to part (7) with Hex key (G) as per diagram.
Using bolt (F) attach connecting iron sheet (J) to part (7) with Hex key (G) as per diagram.
Using bolt (F) attach plastic wedge (H) to part (6) with Hex key (G) as per diagram.
1 Step 10 2 3 1 C C 4 C C C C C 3 2 C C 2 C 3 4 Using Cam lock (C) secure part (1) into parts (2,3,4) with Philips head screwdriver as per diagram. P.
Step 11 D D Place sticker (D) cover the holes as per diagram . P.
Insert shelf support pin (K) into parts (3,4) as per diagram. Make sure you place the four shelf support pins (K) in the same level. So the shelf is not titled .Put part (5) into unit as per diagram. Tilt and rest the adjustable shelf (5) onto the shelf support pins .
Step 13 Final Assembly P.
