Assembly Instructions ASSEMBLY RATING Tools Required for Assembly: The Assembly Rating is a 5-point system that shows the degree of effort needed in assembling a specific product (with 1 being iri § Te easy and & being difficult, Formosa Philips Southerner ot studied) products, two persons are recommended.
90-DAY LIMITED REPLACEMENT PARTS WARRANTY This item comes with 90-day limited replacement parts warranty 10 the original purchaser of new products against defeats in materials and workmanship for a period of ninety (90) days from the date of receipt. This warranty is net transferable.
ASSEMBLY & CARE ADVICE FOR YOUR FURNITURE TO LAST, CORRECT ASSEMBLY AND PROPER MAINTENANCE ARE NECESSARY. PLEASE FOLLOW THE INFORMATION PROVIDED BELOW TO FULLY ENJOY YOUR FURNITURE. BASIC ASSEMBLY TECHNIQUES Hyde highly recommended halt assembly Should BE Dane nerd the arts of fs intended location, Make Sif yeu Have Sad Ugh Space To move around during the assembly ALLAYS have 81 sas in people te Bast with trans porting snd fricasseeing {hie protract ta avid any potential infancy landlord damage.
PER-ASSEMBLY INTRODUCTION Unless your are particularly adept at assembling flat-antiknock-down furniture ‘we understand building ready-to-assemble failure bean frustrating experience for some. To help avoid confusion and to make the assembly process quicker and smoother we have provided some helpful tips. Before you begin the assembly.
CAM LOCK FASTENER ASSEMBLY INSTRUCTIONS Note: Every cam lock bolt must have a cam Jock connector in order to fasten the parts together, {fH Align the cam connector with its Secure the threaded i side opening (or arrow) end of the cam bolt pointing to the small by using a drilled hole. screwdriver. i < Turn right (clockwise) to tighten, Two parts should fit snugly (3) against each other. Insert the cam lock bolt into the per-drilled hole above the cam connector.
ASSEMBLY INSTRUCTIONS Use dowels (#3) on panels STEP : 1 Hardware (1) x PCS Hardware (4) x PCS Hardware (8) x PCS >
ASSEMBLY INSTRUCTIONS STEP: 2 Hardware (7) x PCS Hardware (3) x PCs ® a= EEE 7 ON STEP: 3 Hardware (2) x PCS Use small cam locks (#2) on steps 3. Please read page 5S on how to use fasten cam bolts and cam locks.
ASSEMBLY INSTRUCTIONS STEP: 4 Hardware (8) x PCS STEP: 5 Hardware (2) x PCS Use small cam locks (#2) on sips 5.
ASSEMBLY INSTRUCTIONS STEP: 7 Hardware (7) x 12PC8 Make sure double thin fine on panel is located on the upper hal F.
ASSEMBLY INSTRUCTIONS STEP: 9 Hardware (2) x PCS Hardware (3) x PCS Hardware (8) x PCS Hardware (8) x PCS 7 Make sure panel (3D) mirrors pane (#3. Use large cam locks (#3) ! yg hole on panels (2A. B). Use | stickers (#8) on cam Jocks ~ 0 (3). / Use small cam locks (#2) on panels Use stickers (#9) on cam Jocks G2).
ASSEMBLY INSTRUCTIONS STEP: 11 STEP: 12 Make sure the unit is rested on a flat surface and does not feel loose or wobbly. if it does, double check all setscrews are secured and properly tightened.
