Installation Guide
1of1
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
(2)B10CandelabraBasebulbs60WMaximum,bulbnotincluded.
30-45minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtoensureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.MissingParts?Contactyouroriginalplaceof
purchase.
LightSource:
EstimatedAssemblyTime:
Preparation:
Installation Guide
Package Contents
Fixture Body
x1
C
D
Glass
x2
B
Mounting
Screw
x2
Crossbar
x1
A
STEP 1 Install Crossbar and
Fixture Body
-
A. Pass the supply wires through
the Crossbar (A). Attach the
Crossbar (A) to Outlet Box with
the head of Green Ground
Screw facing you. Secure it with
Outlet Box Screws (not
included). Tighten until snug
B.RefertoStep2forwiring
connections.
C. Attach the Fixture Body (C) over
the Crossbar (A) and secure
with Mounting Screws (B).
Tighten until snug with
screwdrivers.
.
Outlet
Box
Outlet Box Screw
(not supplied)
Supply Wires and
Ground Wire
A
C
B
Figure 1
Figure 2
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture
STEP 2 - Wire Connections
A.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
14.5”
10.75"
6"
6” Dia.
7”
FINISH: Polished Chrome
NOTE: ALL DIMENSIONS ARE ROUNDED UP
TO THE NEAREST 1/4"
Bulb(not
included)
Socket
STEP 3 - Install the Glass and
the Bulb
a. Insert the bulb onto the
socket and screw snugly into
place.
b. Place the Glass (D) into the
hood on the fixture body (C)
and secure with lock screws.
Hand-tighten until snug.
Your fixture is now
assembled and ready to use.
Enjoy!
Figure 3
Lock Screw
D
Pleasegoto our website forproductcleaningtips.Gotothe
Care + Maintenance
selection.
ToolsRequired: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.