W W 52012 CAL KING/ KING BED Hardware Components 1 pc 1 pc 2 pcs 2 sets J K L M N M8X20 4 pcs M6X30 28 pcs M6X70 6pcs M6X45 8pcs M4X32 8 pcs 2 pcs 2 pcs 8 pcs O Q R M6 34 pcs M4 1 pc M5 1 pc 4 pcs W 1 set Page 1
Page 2
Page 3
1 A ach “O” washers to the “K” bolts. Use the assembled “K” bolts to connect the three parts of the headboard “A” together. Please note that the sec on with inserts for the legs should go on the bo om when assembling the headboard. Tighten the “K” bolts. K + O M6X30 8 pcs K O Q 2 A ach “O” washer to “K” bolt. Use the “K” bolts to connect the wing “W” to the ends of the headboard “A”. Tighten the “K” bolts.
4 R J M8X20 J 4 pcs Thread “J” bolts into the holes in the footboard. Do not ghten. These will be ghtened in later steps. 5 Q K + O M6X30 8 pcs K O A ach “O” washers to “K” bolt. Connect the top and bo om of each side rail with a “D” side leg. Use the bolts to a ach. This end will a ach to wing “W” This end will a ach to footboard “C” 6 Hang the hooks at the ends of the side rails onto the “J” bolts in the footboard. Tighten the “J” bolt so the rails are secure.
7 A ach “O” washer to “ L” bolt. Use the “L” bolts to connect the ends of the side rails to the wings “W”. Tighten the “L” bolts. W W W O L Q L + O M6X70 6 pcs 8 M Assemble the slat system by a aching the slats to the “I” supports and “H” legs. First, extend the slats. Then, line up the holes in the slats with the holes in the “I” supports and the holes in the tops of the “H” legs. Use an “M” bolt through the holes to a ach them together.
9 N M4X32 8 pcs Use screwdriver to install“N” screws into side rail cleat N Finally, adjust slat leveling feet to touch floor Page 7
CAUTION: Page 8
