Installation Instructions

INSTALLATION INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
WAR NI NG ! S HUT P O WER OFF AT FUSE OR CI RCUIT BRE AKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Page 2/2
Fig. 4
Fig. 5
Fig. 6
MOUNTING THE FIXTURE, HARDWIRE
VERSION (Fig. 4 & Fig. 6)
1. Shut off power at the circuit breaker and remove the
old fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to lose any small
parts necessary for installation.
3. Remove tabs (1, 2, 3, 4, and 5) from mounting plate
(A) with a screwdriver or pliers.
4. Remove screws (F) and metal plate (G) from fixture
body (D) by using screwdriver (not included). (Fig.6)
5. Loosen the wire connecters located inside the fixture
backplate and carefully remove the power cord and
bushing.
6. Secure mounting plate (A) to the outlet box using
mounting screws (C) (Size: #8-32N*L0.5”).
CONNECTING THE WIRES (Fig. 5)
7. Connect the electrical wires as shown in Fig. 5,
making sure that all wire connectors are secured. If
your outlet has a ground wire (green or bare copper),
connect the fixture’s ground wire to it.
FINISHING THE INSTALLATION (Fig. 4)
8. Align fixture body (D) to mounting plate (A) and
secure with screws (B).
9. Insert plug (E) into the hole in fixture body (D).
Your installation is now complete. Return power to the
outlet box and test the fixture.
Note: Illustration (Fig. 4) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
Touch Switch
E
C
B
A
D
Wire
Connector
Bushing
TDC Power
1
3
2
4
5
D
G
F
Set#
-Mounting plate
-Mounting Screw*2
IMPORTANT: FIXTURE SHOULD BE INSTALLED
BY A QUALIFIED ELECTRICIAN TO ENSURE
PROPER WIRING AND INSTALLATION.