Installation & Assembly

STEP 1:
STEP 2:
Ax4 Bx8 Cx1
Hardware & Tool required
1
C
Pleas
e put Stool Body (1) upside down on a carpeted or padded area.
Positon Stool Base (2) to the bottom of Stool Body (1).
Insert 4 pieces of Bolt (B) into the holes on bottom of Stool Body (1) through the holes on 8 pieces of Plastic washer (B)
and Stool Base (2) as shown.
Use Allen Wrench (C) to tighten all Bolts (A) clockwise until secure.
A
B
B
1
2
Not
e: Make sure to position 1 piece of Plastic Washer (B)
on the bottom
of leg tube, and 1 piece of Plastic Washer (B)
on the top of leg tube for each Bolt (A).
Carefully
turn over the assembled stool.
As
sembly is complete. Your stool is ready to be use now!
BAR STOOL
Page 2 of 2