Owner Manual

ManualsBrandsMercury Row ManualsFurnitureBrandt TV Stand for TVs up to 78"

ASSEMBLY INSTRUCTION

E181-70 70" TV STAND

This page lists all the contents included in the box.

Please take the time to identify the hardware as

well as the individual components to this product.

As you unpack and prepare for assembly, place

the contents on a carpeted or padded area to

protect them from damage.

Shelf Panel T-Shaped Leg

3PCS 4PCS 2PCS

Divider Panel

5PCS

Cross Bar

A B C D

Front Frame

1PC 1PC 1PC 1PC

Top Panel Bottom PanelBack Frame

12PCS

Metal Plate

1PC

Allen Wrench

4MM

2SETS

Anti-Tipping HW

I F

Bolt

1/4”x1/2”

Bolt

1/4”x1/2”

2PCS 4PCS 32PCS

Bolt

1/4”x1/2”

16PCS

Shelf Pin

Summary of content (8 pages)

PAGE 1
ASSEMBLY INSTRUCTION E181-70 70" TV STAND A Front Frame B 1PC E Divider Panel 1PC F 3PCS I Bolt 1/4”x1/2” JF Metal Plate 12PCS G Shelf Panel D T-Shaped Leg K Bolt 1/4”x1/2” Bolt 1/4”x1/2” 32PCS O F Allen Wrench 4MM 1PC Bottom Panel 1PC H Cross Bar 5PCS 2PCS 4PCS N F Top Panel 1PC 4PCS 2PCS M C Back Frame L Shelf Pin 16PCS Anti-Tipping HW 2SETS This page lists all the contents included in the box.
PAGE 2
***Do not tighten screws & bolts until the entire unit is completely assembled. 1 Attach the Bolt (J) to the Front Frame (A) by Allen Wrench (N) as shown. N X2 J A A 2 Attach the Bolt (J) to the Back Frame (B) by Allen Wrench (N) as shown.
PAGE 3
Attach the T-Shaped Leg (G) to the Back Frame (B) by using Bolt (K) as shown. B G G X2 K G K 4 Unfold the Front Frame (A) as shown.
PAGE 4
5 Attach the Cross Bar (H) to the Front Frame (A) by using Bolt (K) as shown. H A H H K 6 K H H X5 Attach the Back Frame (B) to the Front Frame (A) and Cross Bar (H) by using Bolt (K) as shown.
PAGE 5
7 Place Bottom Panel (D) on Cross Bar (H) as shown. H 8 D H H H Insert Metal Plate (M) into the holes on the Front Frame (A) and Back Frame (B) as shown.
PAGE 6
9 Slide the Divider Panel (E) through the Metal Plate (M). Make sure the dividers are facing correctly as shown. E E E B A D 10 Attach Top Panel (C) to the Front Frame (A) and Back Frame (B) by using Bolt (K) as shown.
PAGE 7
11 Insert Shelf Pin (L) to the holes of Divider Panel (E) and side panels. Then place Shelf Panel (F) onto the Shelf Pin (L) as shown.
PAGE 8
12 *NOTE: WE RECOMMEND THAT YOU ATTACH THE PRODUCT TO YOUR WALL AS A SAFETY PRECAUTION USING ANTI-TIPPING HW (O) AS BELOW INSTRUCTION. Attach Mounting Plate to the Back Frame (B) by using Bolt (I), make sure the Mounting Plate extend DOWNWARD. Drill 2 holes in your wall approximately 2” (Inches) BELOW the corresponding positions of Mounting Plate and insert Wall Anchor as shown. *NOTE: You may need to tap LIGHTLY with a rubber mallet.