Installation & Assembly

3
2
Cleaning & Care
Treat surface with care. Surface is resistant to scratches but is not scratch resistant. Clean surfaces with a
dry or damp soft cloth. Do not use abrasive cleaners. Hardware may loosen over time. Periodically check that
all connections are tight.
N
P
O
Wall
Wall
1
Wall
Wall
2
3
E
E
A
A
D
D
D
B C
*NOTE: WE RECOMMEND THAT YOU ATTACH THE PRODUCT TO YOUR WALL AS
A SAFETY PRECAUTION.
(1) Drill 2 (Two) holes in your wall approximately 2” (Two Inches) BELOW the corresponding
positions of Mounting Tabs (D) and insert Wall Anchors (C) as shown.
*NOTE: You may need to tap LIGHTLY with a rubber mallet.
(2) Attach Mounting Tabs (D) to Wall Anchors (C) with Wood Screws (B), using a Philips
Head Screwdriver (not provided), make sure the Mounting Tabs (D) extend UPWARD.
(3)Now connect the corresponding Mounting Tabs (D) with Plastic Mounting Straps (E) and
tighten as desired before locking in place.