Installation & Assembly

ASSEMBLY INSTRUCTION

Bolts

1/4”x1/2”xØ13

(Anti-Tipping)

Allen Wrench

1/4”

(Anti-Tipping)

A B C D

F G

Night Stand

2PCS 2PCS

1PC 2PCS 2PCS 4PCS

Wood Screws

4 x 25 x 9mm

(Anti-Tipping)

Wall Anchors

(Anti-Tipping)

Mounting Tabs

(Anti-Tipping)

Plastic Mounting

Straps

(Anti-Tipping)

1PC

This page lists all the contents included in the box.

Please take the time to identify the hardware as

well as the individual components to this product.

As you unpack and prepare for assembly, place

the contents on a carpeted or padded area to

protect them from damage.

CHERRY FINISH STACKED WOOD NIGHT STAND

PAGE 1
ASSEMBLY INSTRUCTION CHERRY FINISH STACKED WOOD NIGHT STAND A B Night Stand 1PC E Plastic Mounting Straps (Anti-Tipping) 2PCS C Wood Screws 4 x 25 x 9mm (Anti-Tipping) 2PCS F 2PCS G Bolts 1/4”x1/2”xØ13 (Anti-Tipping) 2PCS Wall Anchors (Anti-Tipping) D Mounting Tabs (Anti-Tipping) 4PCS Allen Wrench 1/4” (Anti-Tipping) 1PC This page lists all the contents included in the box. Please take the time to identify the hardware as well as the individual components to this product.
PAGE 2
***Do not tighten screws & bolts until the entire unit is completely assembled. 1 Attach Mounting Tabs (D) to the BACK of the Night Stand (A) with Bolts (F) and Allen Wrench (G), making sure the Mounting Tabs (D) extend DOWNWARD as shown.
PAGE 3
2 *NOTE: WE RECOMMEND THAT YOU ATTACH THE PRODUCT TO YOUR WALL AS A SAFETY PRECAUTION. (1) Drill 2 (Two) holes in your wall approximately 2” (Two Inches) BELOW the corresponding positions of Mounting Tabs (D) and insert Wall Anchors (C) as shown. *NOTE: You may need to tap LIGHTLY with a rubber mallet. (2) Attach Mounting Tabs (D) to Wall Anchors (C) with Wood Screws (B), using a Philips Head Screwdriver (not provided), make sure the Mounting Tabs (D) extend UPWARD.