Assembly Instruction

ASSEMBLY INSTRUCTIONS
Thank you for purchasing this quality product. Before beginning, please check the packing material carefully for
small parts which may have come loose inside the carton during shipping. Please do not discard any packing
material until all parts have been located. If any parts are missing, please contact your dealer for replacement.
Parts & Hardware List
PARTS LIST
QTY
NO.
HARDWARE LIST
QTY
A
UPHOLSTERY SEAT CUSHION WITH
WOOD FRAME
1 PC
# 1
1-1/2’’ L
BOLT + SPRING WASHER + FLAT WASHER ----- 5/16” Dia
2 SET
B
CHAIR BACK FRAME
1 PC
# 2
3’’ L
BOLT + SPRING WASHER + FLAT WASHER ----- 5/16” Dia
4 SETS
C
FRONT LEG
2PC
# 3
2-1/2’’ L
BOLT + SPRING WASHER + FLAT WASHER ----- 5/16” Dia
4 SETS
# 4
12*85mmL
WRENCH
1 PC
#4
#2
#4
#3
Assembly Procedures:
TOOLS REQUIRED: WRENCH #4 (See Hardware List).
NOTE: FIRST READ THE CHAIR LEVELING INSTRUCTIONS. THIS IS AN ADDITIONAL ASSEMBLY SHEET FOUND INSIDE THE CARTON.
PLACE ALL CHAIR PARTS ON A CLEAN, CUSHIONED AREA TO PREVENT SCRATCHING THE FURNITURE. MAKE SURE THE
FEET ARE FREE OF STAIN, STAPLES, SCREWS AND NAILS.
Assembly Steps:
STEP 1: REMOVE THE PLASTIC COVER ON THE UPHOLSTERED SEAT. ASSEMBLE THE SEAT FRAME (A) TO THE BACK FRAME (B).
STEP 2: ASSEMBLE THE FRONT LEGS (C) TO THE SEAT FRAME (A).
** NOTE: DO NOT TIGHTEN ALL THE BOLTS UNTIL THE CHAIR HAS BEEN PUT ON A FLAT SURFACE TO ADJUST & LEVEL ALL THE
LEGS SO THAT THEY DO NOT WOBBLE. ONCE ADJUSTED THEN TIGHTEN ALL THE BOLTS. DO NOT OVER TIGHTEN.
Upholstered Side Chair