Installation & Assembly

Step 3

Step 4

Step 5

Place the Loveseat on a LEVEL SURFACE to see if it wobbles.

If it wobbles, press firmly down on Seat and Backrest at the same time. This will help to

ensure all Bolts and gaps reach full alignment status.

If no wobbles found, proceed to tighten all the bolts.DO NOT fully tighten a BOLT in one go

and then move on to the next. Rather,In a sequential manner,gradually tighten each Bolt

until all bolts are evenly secured.

This methodology will ensure maximum eveness once all Bolts are fully tightened.

Now tighten all the bolts untill the chair is not wobbling on the LEVEL SURFACE.

Your Loveseat is ready for use.

This Loveseat can only be used on a flat, level surface.

Place the velcro non-woven fabric cover back underneath the Seat(D)

Install the legs (A&B1&B2) to Seat by using the Medium Bolt (②) + Spring Washer (③) +

Washer(④) as shown. Use the Allen Key(⑤) to fasten all bolts.

Caution:Do not fully tighten.

②

③

④

⑤

4 of 5