Caution: You must read this before you proceed.
B1 Right Back Leg 1 B2 Left Back Leg 1 C Backrest 1 D Seat 1 Description Qty ① Long Bolts M8X60mm 3 ② Medium Bolts M8X40mm 17 ③ Spring Washers 20 ④ Washers 20 ⑤ Allen Key 1 Label Picture Backrest (C) Seat (D) Front Leg (A) FRONT FACING Right Back Leg (B1) Front Leg (A) 2 of 5
This Loveseat has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Loveseat parts, the above picture is to help you put the various Loveseat parts into perspective. Please read through the instructions to familiarise yourself with the parts and steps before assembly. Step 1 REMOVE the non-woven fabric from under the seat, take out the legs and hardware accessories. Step 2 ② ⑤ ① ③ ④ Step 2.1 ② ④ ② ③ ④ Step 2.
Step 3 Place the velcro non-woven fabric cover back underneath the Seat(D) Step 4 B1 ⑤ ② ③ B2 ④ A A Install the legs (A&B1&B2) to Seat by using the Medium Bolt (②) + Spring Washer (③) + Washer(④) as shown. Use the Allen Key(⑤) to fasten all bolts. Caution:Do not fully tighten. Step 5 Place the Loveseat on a LEVEL SURFACE to see if it wobbles. If it wobbles, press firmly down on Seat and Backrest at the same time. This will help to ensure all Bolts and gaps reach full alignment status.
of 5
