Assembly Instruction

Table Of Contents

Do not tighten screws & bolts until the entire unit is completely assembled.

***

Cleaning & Care

Treat surface with care. Surface is resistant to scratches but is not scratch resistant. Clean surfaces with a dry

or damp soft cloth. Do not use abrasive cleaners. Hardware may loosen over time. Periodically check that all

connections are tight.

Attach Tension Bar (D) to Side Frame (C) using Machine Screw (H) and Phillip Screwdriver (K). Then

secure middle using Machine Screw (H) and Nut (I). While holding Nut (I) with Spanner Wrench (J),

but not tighten it.

Attach Side Frame (C) to Top Panel (A) using Screw (E) and Allen Wrench (F) as shown. Attach Side

Frame (C) to Lower Panel (B) using Wood Screw (G) and a Phillip Screwdriver (K) as shown. Tight all

screws and carefully turn the assembled unit upright.