Installation & Assembly_Table

Step 4
Step 3
Your Table is ready for use.
Place the table on a LEVEL SURFACE to check for wobbles.
If it wobbles,with 2 to 3 adult partners, lift the table to some 30cm to 50cm height from the ground.
Keep your feet and toes well away from the drop zone.
Drop the table freely and vertically with the four legs, hitting the ground, all at the same time.
This Drop Test will help to ensure that all the bolts and gaps to all reach full alignment status.
Test again for evenness on a LEVEL SURFACE.
If no wobbles found, with assistance from 2 to 3 adult partners, slowly and steadily, turn the table upside
down.
Then, proceed to tighten all bolts in a sequential manner.
CAUTION : When tightening these bolts, tighten sequentially.
DO NOT tighten any screw fully and then towards the next one.
This would cause the frame to warp.
If there is still wobbles, loosen the bolts and execute this same drop tests.
WARNING!! IF table IS NOT STABLE , IT COULD LEAD TO DAMAGING THE PRODUCT.
If wobble
Test again
30CM~50CM
Page 4 OF 5