User's Guide Part 2

PureWave Quantum 6600 User Guide v2.1
Page 59
Figure 46: Sector General Configuration Parameters
At the Main Web GUI Interface Screen select the Configuration Tab, select sector Main Menu Option,
general Main Menu Sub-Element, 1 and then system. This will display the currently configured Sector
General Provisioning window. There are a further two sub-elements to this window but only one is
displayed.
These sub-elements are:
system. This option enables the User to configure the parameters.
state. This is a duplication of the windows and parameters that are contained within the system
options. These are "read-only" screens and provide an indication as the current state or status
of the system parameters.
The status of the following parameters are displayed and the User is free to configure as required (refer
to Figure 47). To edit and configure then the User must enter the Edit Mode (select Edit
Private/Exclusive):
Base Station ID. This is the unique identifier that specifically indentifies the Base Station to the
Subscribers. It is not recommended that this is changed.
Cell ID. This is a numeric identifier that the User will define to a cell (acceptable range is 0 to 31).
Convergence Sublayer Type. This is the convergence sublayer type that is globally set for the
sector. The available options are ETHERNET_CS and IPv4_CS. The default is ETHERNET_CS.
Downlink Broadcast Rate. This is a User defined parameter that specifies the maximum
reserved Downlink (DL) rate for the purposes of IP broadcast traffic. This rate can be set up to
1Mbps and once set it is reserved and as such it is not available for Data Traffic. The default is
64000.