User's Guide Part 2

PureWave Quantum 6600 User Guide v2.1
Page 55
(8) Another useful command is the ability to change the default Quantum prompt. When the User is
in the config mode, type system hostname <Hostname> (refer to Figure 42). The change must
be written to memory and the Base Station has to be rebooted.
Figure 42: Base Station CLI Hostname Change
(9) To change the username admin password, when the User is in the config mode, type
username admin password
Password <new admin User Password>
The change must be written to memory (Figure 43).
Figure 43: Base Station CLI Username Password Change
3.5.3 Base Station Configuration Parameters
There are a number of key parameters that must be configured, as a minimum, prior to deployment and
operation of the Base Station. Table 11 is a list of these parameters. In addition to these key parameters,
there are a number of other parameters that can be configured on the Base Station. Such parameters
can be left in their default configuration for "nominal" Base Station operation but there is the option to