User's Guide Part 2

PureWave Quantum 6600 User Guide v2.1
Page 98
To ensure that the User has a stored backup of the running configuration file, then the User
would export and then upload the relevant files. To restore a previously stored file from its
remote location, then the User would download and then import.
3.5.4 Connecting a Subscriber Station
The procedures for provisioning each make and model of Subscriber CPE device vary and hence are
beyond the scope of this document. However, PureWave have prepared general documentation that
details recommend procedures to configure specific Subscriber units. Please refer to this documentation
for further details.
When a Subscriber CPE is powered on and configured for an appropriate Base Station, if that
Base Station is configured for auto-provisioning, the Subscriber CPE will automatically connect
to the Base Station and it will be assigned the default Client Profile (Client Profile 1).
The User however has the complete flexibility to pre-configure the Subscriber CPE and has the capability
to assign it to a specific Client Profile.
The procedure to configure a Subscriber CPE is:
(1) For the particular Subscriber CPE that you wish to provision please record the Subscriber MAC
address. This is written on the CPE label.
(2) At the Main Web GUI Interface Screen select the Configuration Tab and then the cpe Main
Menu Option. This will display a list of all Subscriber CPEs that have been specifically configured
on the Base Station (refer to Figure 92). If there are none listed then none have been
configured.
Figure 92: CPE Main Menu Option