User's Guide Part 2

PureWave Quantum 6600 User Guide v2.1
Page 70
Figure 60: Sector Radio Settings Configuration
After making the various configuration changes, the User will need to "Commit" and "Save" the
changes.
The Radio Settings parameters that the User can configure are defined below:
Antenna Gain. This is the gain (in dB) for the Antenna that the Base Station is connected to. The
default setting is 0 but the User is free to enter any value.
Cable Loss. This is a loss of the cable (in dB’s) from the Base Station to the Antenna. The default
setting is 0 but the User is free to enter any value.
Center Frequency. This is the center frequency of the Base Station and it must match with what
is configured on the Subscribers. The default setting is relative to the frequency range of
operation of the Base Station. To re-configure, the center frequency has to be input in KHz.
Power Output. This is the radio output power in dBm. The default setting is relative to the
frequency range of operation of the Base Station. The User must ensure that the maximum
output power is defined as described in section 2.3.2.2 "Computing EIRP Power".
Contention Based Mode may be enabled on the Radios to support the upper 25 MHz of the 3.65 GHz US
ISM band. To utilize Wimax Contention Based Mode, at the Main Web GUI Interface Screen select the
Configuration Tab, select sector Main Menu Option, advanced Main Menu Sub-Element, 1, and then
radio and contention-based mode. The display is split into two grouping sections. These sections do not
fit onto one screen and therefore the User has to scroll down to view etc (refer to Figure 61).
Mode (enable/disable). Allows the feature to be enabled or disabled
Carrier Sense Threshold. Set to -85.0 dBm