User's Guide Part 2

PureWave Quantum 6600 User Guide v2.1
Page 62
Figure 50: Sector External IP Address Changed
At the Main Web GUI Interface Screen select the Configuration Tab, select sector Main Menu Option,
general Main Menu Sub-Element, 1, state and then system. This provides another view that will display
the current configuration of the Sector. Even if the User enters the Edit Mode (select Edit Private or Edit
Exclusive), no parameters are made available for editing. The options to configure these parameters are
contained under the system and then base station options.
There are three distinct groups to this window (refer to Figure 51 and Figure 52).
Sector External ASN-Gateway. This contains the parameters:
o IP Address. This is the IP Address of the external ASN Gateway.
o Port Number. This is the IP port number that is used to communicate with the ASN
Gateway.
o Nwg-version. This is the current firmware version of the ASN Gateway.
Sector General Provisioning
o Base Station ID. This is the unique identifier that specifically indentifies the Base Station
to the Subscribers.
o Cell ID. This is a numeric identifier that the User will define to a cell.
o Convergence Sublayer Type. This is the convergence sublayer type that is globally set
for the sector.
o Downlink Broadcast Rate. This is the maximum reserved Downlink (DL) rate for the
purposes of IP broadcast traffic.
o Maximum Supported CPEs. This specifies the maximum number of Subscriber CPEs
(200) that can be connected to the Base Station.
o Mode. This specifies whether the Base Station Mode is connected to an ASN Gateway.
Sector External Radius Server Settings
o IP Address. This is the IP Address of the external radius server.