User's Guide Part 1

PureWave Quantum 6600 User Guide v2.1
Page 18
Note that Installation and weatherproofing must be completed by a professional
installer. Please refer to the PureWave Quantum 6000 Base Station Installation Guide for
detailed instructions.
The function of each Base station connector/port is described in Table 1. Note that every connector
present must be terminated to ensure proper Base station operation. Please refer to the PureWave
Quantum 6600 Installation Guide for comprehensive installation procedures.
Table 1: Base Station Connector Descriptions
Connector
Function
PWR
-48VDC power source inputs for the unit.
DC power connector: LTW BB-04PMMS-LC7001 (chassis), LTW BB-04BFFA-LL7001
(mate)
GND
This M5 screw provides a ground connection point to the Base Station. It is the
installer’s responsibility to ensure that the unit is professionally grounded and
complies with all relevant local codes.
GPS
N-type connector for mandatory external GPS antenna. 3.3V power on center pin.
ETH-1
This Gigabit Ethernet port serves as the data traffic backhaul
Interface and also provides for in-band management of the Base Station. Note that
this port may be physically routed directly to the operator’s network equipment, or it
may be daisy-chained through additional PureWave Quantum sectors by routing it to
another unit’s ETH-2 port.
Cat-5 (RJ-45), Single-Mode Fiber (HartingPull/Han 3 A), and Multi-Mode (LC duplex)
Fiber options are available for the ETH-1 port.
ETH-2
This Gigabit Ethernet port serves as an incoming daisy-chain port from a neighboring
sector, and may be used for out-of-band management of the Base Station. It may
also be used to connect to an external device, such as a web camera. Daisy-chained
traffic is aggregated and passed through the ETH-1 port.
Cat-5 (RJ-45), Single-Mode Fiber (HartingPull/Han 3 A), and Multi-Mode (LC duplex)
Fiber options are available for the ETH-2 port.
CONSOLE
RJ-45 based RS-232 port for CLI control via a console.
Defaults settings are 38400, 8 data bits, 1 stop bit, no parity bits, no flow control.
ANT 1-6
N-type Tx / Rx Antenna Ports.