User's Guide

Quantum 2200 Installation Guide v2.1
Page 39
Weatherproofing Procedures
The following procedure is illustrated for an N-type antenna connector (without surge connector) but
applies to all connector types.
Step 1:
Tighten the connection with a torque wrench to the proper torque value (12-15lbs for an N-
type connector) to ensure that correct internal seals and surface contacts are made. One
recommended torque wrench for an N-Type connector is the Andre 244379 and is shown in
Figure 33.
Figure 33: Torque Wrench for N-Type Connector
Step 2:
Wrap the connection with a layer of 3/4” (19-mm) plastic tape, starting at 1” (25 mm) from
the connector. Overlap the tape to half-width as illustrated in Figure 32 and extend the
wrapping over the entire connector. Avoid making creases or wrinkles. Smooth the tape
edges. See Figure 34.
Figure 34: First Plastic Tape Layer
Step 3:
Cut a 5” (125-mm) length of rubber tape. Expand the width of the tape by stretching it such
that it will wrap completely around the connector and cable. Press the tape edges together
so that there are no gaps. Press the tape against the connector and cable. The tape should
extend 1” (25 mm) beyond the plastic tape on the cable (Figure 35).