Quick Start Guide

Designed for Operators, by Operators

95 | P a g e

CPE will obtain its IP address through DHCP Server. When changed from the defaults value a static

IP address is used for the Provisioning. The CPE device’s WAN interface must be configured with

the same IP address.

• IP Netmask. Applicable/Visible only when the CPE is configured for IPV4_CS Convergence

Sublayer mode and the base station operated in Stand Alone mode. Defines the Subnet Mask.

Currently only a single IP Address is possible, thus the default value of 255.255.255.25.255 should

not be changed!

• Customer ID. This is a free format text field that enables the User to uniquely define a Subscriber.

This is edited by selecting the notepad icon.

• Maximum Uplink Rate. The User can select the maximum uplink modulation rate. This will

effectively provide a cap on the maximum data traffic rate. This direction is defined as the

Subscriber to Base Station. This is selected via the drop-down menu and the options are:

o QAM64 5/6

o QAM64 3/4

o QAM64 2/3

o QAM64 1/2

o QAM16 3/4

o QAM16 1/2

o QPSK 3/4

o QPSK 1/2

• Maximum Downlink Rate. The User can select the maximum downlink modulation rate. This will

effectively provide a cap on the maximum data traffic rate. This direction is defined as the Base

Station to Subscriber. This is selected via the drop-down menu and the options are: