Quick Start Guide

Designed for Operators, by Operators
94 | P a g e
3. The User now must enter the Edit Mode (select Edit Private or Edit Exclusive). The <Add cpe>
option will appear (refer to Figure 96).
Figure 96 Add Subscriber CPE Option
4. The User must select the <Add cpe> option. A Key Settings window will appear. The User is
prompted to enter the Subscriber CPE MAC Address. The MAC Address must be entered in Upper
Case letters only and using a colon (:) to separate the digits, e.g. 00:17:C4:8F:9B:34. If the User
selects the “?” Command Menu Option within the window then a reminder prompt will be
displayed. Once the MAC Address has been entered the User must select the Add command
button (Figure 97).
Figure 97 Add Subscriber CPE MAC Address
5. The User will now be presented with the Subscriber configuration options. The options to select
are (Figure 98):
• Convergence Sublayer Type. The User can select from a drop-down menu. The default option is
Ethernet CS and the available options are:
o IPV4_CS.
o ETHERNET_CS . This is the default setting; the Base Station operates in Standalone mode.
• Client Profile. This profile can be selected from a drop-down menu. The User can select <unset>
or from one of the user configured profiles (1 through 64).
• IP Address. Applicable/Visible only when the CPE is configured for IPV4_CS Convergence Sublayer
mode and the base station operated in Stand Alone mode. 0.0.0.0 value (default) means that the