Quick Start Guide

Designed for Operators, by Operators
73 | P a g e
Figure 73 WiMAX Learning Table
The parameters in the learning table are as follows:
o Sector. Represents the Sector ID on which the device was learned. For Quantum 6600
this is always 1.
o MAC. Mac Address of the device learned in the bridge learning table
o DEV MAC. The MAC Address of the device(s) behind the CPE. This will be the MAC
address of the mobile station (MS) if it operates in NAT Mode or is USB type. There
can be up to 10 MAC addresses behind a CPE if the Base Station operates in Bridge
Mode – Stand Alone. In case the Base Station operates in IP CS – Stand Alone mode
the MAC address will always be the one of the MS. Each IP should be displayed as a
separate entry.
o IP Address. The IP Addresses of the devices behind the CPE. This is relevant only in
case the base station operates in IP CS Stand Alone mode. In other cases, this will
not return any value. In case the CPE operates in NAT/Router mode or is of USB type
this will be usually a single entry with the IP Address.
o Static. If the entry is manually provisioned or if the IP Address was obtained through
DHCP Server. This is relevant only for IP CS Stand Alone mode.
o Ageing. Represent the time in seconds of the device since the last frame was received
originating with the matching source MAC Address. Aging is not applicable to IP CS
Stand along mode, where there is IP Address learned – No Ageing.