Quick Start Guide

Designed for Operators, by Operators
5 | P a g e
Changes or modifications not expressly approved by Mercury Networks, LLC. may void the user’s authority
to operate this equipment.
The 2.3, 3.3, and 3.5 GHz products have the CE (European Conformity) Mark.
Note: This device must be professionally installed, and the operator and/or the licensed
spectrum holder have the responsibility to comply with FCC regulations.
Note: This device must be professionally installed, and the operator and/or the licensed
spectrum holder have the responsibility to comply with FCC regulations.
Note: The contention protocol MUST be turned on and used for the specified band
(3.65GHz - 3.7 GHz) in the specified country or wherever FCC rules and regulations are
enforced. Failure to comply makes the operation of this device illegal.
Safety Precautions
When operating or installing this equipment, please observe the following precautions to minimize the
risk of danger or personnel injury:
NEVER install equipment if there is a chance of lightning or other adverse weather
conditions.
NEVER install equipment in a wet location unless the equipment is specifically design for
wet locations.
NEVER touch un-insulated wires or terminals unless the wire has been disconnected from
any equipment.
ALWAYS use caution when installing or modifying cables.
ALWAYS disconnect all lines and power connections before servicing or disassembling
this equipment.
ALWAYS assume that all components and assemblies are static sensitive and always
follow local ESD-prevention guidelines to prevent equipment damage.
For any external power supply that provides the power source for the Mercury Networks
equipment, replace any power supply fuse with the same rating or equivalent; otherwise
Mercury Networks cannot not be responsible for any subsequent damage to the
equipment.