User's Guide

PureWave Quantum 6600 Installation Guide v2.1
Page 8
Safety Precautions
When installing this equipment, please observe the following precautions to minimize the risk of danger
or personnel injury:
NEVER install equipment if there is a chance of lightning or other adverse weather
conditions.
NEVER install equipment in a wet location unless the equipment is specifically design for wet
locations.
NEVER touch un-insultated wires or terminals unless the wire has been disconnected from
any equipment.
ALWAYS use caution when installing or modifying cables.
ALWAYS disconnect all lines and power connections before servicing or disassembling this
equipment.
ALWAYS assume that all components and assemblies are static sensitive and always follow
local ESD-prevention guidelines to prevent equipment damage.
For any external power supply that provides the power source for the PureWave equipment,
replace any power supply fuse with the same rating or equivalent; otherwise PureWave
Networks cannot not be responsible for any subsequent damage to the equipment.
For performance and safety reasons, only power supplies listed for use with telephone
equipment by a Nationally Recognized Testing Laboratory (NRTL) should be used with
equipment.
ALL wiring external to the product(s) should follow the provisions of the current edition of
the National Electrical Code.
These units contain no user serviceable components. Only authorized service personnel
should service or repair these units. Use only isolated Class 2 Power Source, Rated 48V dc
5.0A Minimum.