User's Guide

PureWave Quantum 6600 Installation Guide v2.1
Page 41
Figure 36: First Rubber Tape Layer
Step 4:
Start wrapping a layer of 2” (50-mm) plastic tape 1” (25 mm) below the rubber tape,
overlapping at half width (Figure 37). Finish the wrap at the flange of the antenna connector
and cut the tape.
Figure 37: Wrapping Plastic Tape on Top of the Rubber Tape
Step 5:
Start wrapping three layers of 3/4” (19-mm) plastic tape, 1” (25 mm) below the previous 2”
(50-mm) wrap, overlapping at half width (Figure 38) until the entire connector is wrapped.
The tape should be applied in one strip if possible. A strip can be coiled onto an applicator
such as a pencil. Apply only enough tension to get good adhesion and keep the tape smooth.