User's Guide

PureWave Quantum 6600 Installation Guide v2.1
Page 33
This DC power connector assembly has been provided as part of the Basic DC Installation Kit (Table 7)
and consists of a 4-pin female power connector plug, a set of crimp contacts, and a cable clamp. The
connector with pin assignments is shown in (Figure 19).
Figure 19: IP67 DC Power Connector and Pin Assignments
To successfully complete the power cable assembly you will need the following tools (not provided).
Wire-strippers
Needle-nose pliers
Phillips Screwdriver
Crimping tool
The Tyco 91519-1 Crimp Tool was specifically designed for the pins of the Quantum power connector.
However, due to its high cost we have focused on a procedure for creating the connector with the much
more affordable Waldom W-HT1921 Crimp Tool and plus the Tyco / AMP 200893-2 Insertion Tool. All
are shown in Figure 20. If you choose to use the optional Tyco crimp tool then please follow the
instructions included with the tool for the proper crimping procedure.
Figure 20: Crimp and Insertion Tools for the DC Power Connector