User's Guide

PureWave Quantum 6600 Installation Guide v2.1
Page 31
Step 1:
Slip the Sealing Nut onto the RJ-45 cable.
Step 2:
Place the screw nut onto the housing with the threads facing forward
Step 3:
Insert the seal into the housing
Step 4:
Insert the cable through the seal and housing exiting the front of the housing
Step 5:
Strip cable sheath
Step 6:
Crimp the RJ 45 plug onto the cable
Step 7:
Pull the cable back so the plug fits into the housing.
Step 8:
Secure the sealing nut in place
Step 9:
Stick the gasket onto the front end of the housing
The fully assembled connector is shown in Figure 18 and can now be attached to each base station RJ-45
connector thus creating a weather protected connection. Additional weatherproof wrapping, as
described in Appendix A is still, however, recommended.
Figure 18: Assembled RJ-45 IP67 Weatherproof Housing