User's Guide

PureWave Quantum 6600 Installation Guide v2.1
Page 15
3 Mounting the Base Station
3.1 Fundamentals
The back side of the base station includes 6 metric M8-1.25 threaded mounting holes, as shown in
Figure 4.
Figure 4: Base Station Mounting Holes
Because the mounting holes are recessed, provisions must be made to provide for spacing between the
mounting points and the mounting bracket or surface, as exemplified in Figure 5.
Figure 5: Example of Mounting Point with Spacing Hardware
It is imperative that proper airflow be maintained on all sides of the base station and that all
heat sinks remain unobstructed. In the case of wall or surface mounting a minimum of 2” of
space should be maintained between the base station and mounting surface.