User's Manual

Quantum 1000 Base Station User
2.7 GPS
This port provides the connection between the GPS antenna (external) and the GPS receiver
(internal). GPS is used by the Base Station to synchronize its TDD gate to those of Base Stations in
neighboring cells. Connect the coaxial cable from the external GPS antenna to the SMA
connector marked “GPS” on the bottom right corner
GPS antennas are shown in figure 1
Figure 18 -
Base Station Underside View of GPS Antenna Connection
Figure 19 -
Typical
Quantum 1000 Base Station User
Guide
Rev 1.1, Page
This port provides the connection between the GPS antenna (external) and the GPS receiver
(internal). GPS is used by the Base Station to synchronize its TDD gate to those of Base Stations in
neighboring cells. Connect the coaxial cable from the external GPS antenna to the SMA
connector marked “GPS” on the bottom right corner
of the Base Station unit (refer to figure 1
GPS antennas are shown in figure 1
9.
Base Station Underside View of GPS Antenna Connection
Typical
Base Station Sector External GPS Antenna’s
Rev 1.1, Page
23 of 70
This port provides the connection between the GPS antenna (external) and the GPS receiver
module
(internal). GPS is used by the Base Station to synchronize its TDD gate to those of Base Stations in
neighboring cells. Connect the coaxial cable from the external GPS antenna to the SMA
-type female
of the Base Station unit (refer to figure 1
8). Typical
Base Station Underside View of GPS Antenna Connection