User's Manual Part 2

Quantum 1000 Base Station User
Figure 44 -
PolyPhaser Model AL
Figure 45 –
Altelicon Model AL
Care must be undertaken when installing the surge protectors. I
irrelevant as to the direction of installation. If the device is uni
ensure that the protected side of the surge protector is connected to the Base Station. In the case
Polyphasor the N-
type male connection is connected directly to the Base Station output and the N
female connection is connected to the Base Station to Antenna cable. The male to female design of the
surge protector means that it is very diffic
ground wire is connected to the ground lug that is provided with the surge unit (see figure 4
Quantum 1000 Base Station User
Guide
Rev 1.1, Page
PolyPhaser Model AL
-LSXM-ME
Surge Protector (with ground lug)
Altelicon Model AL
-NMNFB-9
Surge Protector (with ground lug)
Care must be undertaken when installing the surge protectors. I
f the device is bi-
directional then it is
irrelevant as to the direction of installation. If the device is uni
-
directional therefore it must be installed to
ensure that the protected side of the surge protector is connected to the Base Station. In the case
type male connection is connected directly to the Base Station output and the N
female connection is connected to the Base Station to Antenna cable. The male to female design of the
surge protector means that it is very diffic
ult to incorrectly connect. In addition it is recommended that a
ground wire is connected to the ground lug that is provided with the surge unit (see figure 4
Rev 1.1, Page
43 of 70
Surge Protector (with ground lug)
Surge Protector (with ground lug)
directional then it is
directional therefore it must be installed to
ensure that the protected side of the surge protector is connected to the Base Station. In the case
of the
type male connection is connected directly to the Base Station output and the N
-type
female connection is connected to the Base Station to Antenna cable. The male to female design of the
ult to incorrectly connect. In addition it is recommended that a
ground wire is connected to the ground lug that is provided with the surge unit (see figure 4
6).